Solution To Fix Wavlink Extender Errors

If you are facing trouble with your Wavlink extender device and you try many tips but fail to fix the issue. Then don’t worry in that case this page will help you.

Place The Extender in Another Location

After changing or placing the extender in a good location in your office or house. The best place to place an extender is the central location of the house. But make sure not to place the extender near to electronic appliances. By doing this you can easily resolve errors.

Upgrade Software Of Extender

To upgrade the software of an extender you will be required to access the Wavlink web management page. Follow lower directions.

• First, take a computer and make sure the computer is linked to the extender.
• Now, open the browser and type wifi.wavlink.com in the address bar.
• Next, search for the network administrative option and then click on the software upgrade option.
• Later, install the file on the computer and wait a minute to complete this method process.

Power cycle The Wavlink Extender

To power cycle the Wavlink extender device, follow the below points:-

• Initially, push the power button of an extender to turn it off.
• After that, take out the power plug of the Wavlink extender from a socket.
• Now, rest a few minutes and place the extender plug back into the socket.
• In the end, press the power button of an extender to turn it back on.

Reset All Previous Settings

To reset all the extender’s previous settings you will be required to press the button of the extender with the help of a paperclip. By doing this all the LEDs of an extender will turn off which means your device is completely reset.

Note: After performing the reset method process you will be required to do the Wifi.wavlink.com setup process again.

Setup Wavlink Extender By WPS

Initially, place the extender closer to the router. After that, look up the WPS button on the extender and press it. Next, punch the WPS button of the host router. By doing this the WPS LED starts blinking solid on both units. As the solid WPS LED defines the extender and router both gadgets successfully connect.

Tip:- If your host router does not support the WPS button then try another method.

Configure Extender By Ethernet Cable

To do this method process, take a WiFi device and connect it to the Wavlink extender default network by ethernet cable. Now, on that WiFi connected device type, launch Chrome and hit wifi.wavlink.com setup web portal. After that fill information which is shown on the page. The hilt on the start setup button and follow all the display instructions to complete the setup process by ethernet cable of the Wavlink extender.

After the study of this post, you will be able to fix the error of the Wavlink extender easily without taking the help of a technician. In case, if the above troubleshooting tips do not help to resolve the error then don’t worry, just contact our technician team and talk with them – discuss your query – and fix the issue.