WiFi Extender N300 Setup: Complete Configuration Guide
Extended devices are commonly used by people to create a stable network. This device is used to eliminate network coverage issues that cause weak signals or no signal zone in a particular area of the house or office. With the setup of an extended device along with the router device one can extend the coverage of the router network. Adding WiFi extender N300 to your home network is not as difficult as you thought. If you are also facing networking problems then you can perform WiFi extender N300 setup to boost the network. Check out the step by step guide here which will help you out in adding the device to your home network.
WiFi Extender N300 Setup Process
The below given guide will guide you to add the extended device into your home network using the WPS method or web method. Both the methods are simple to follow. Here are the steps for the methods which you should go with to configure the device.
WPS Method
Wbs method is the simplest method to follow. It is a button based method in which you just have to push the WPS button on both your router device and extended device to connect them. Make sure your extender is turned on properly and its led is stable before performing the push button method.
Web Based Method
Web based method is a little time consuming process to perform but it allows you to perform several customisations. Here are the steps you have to follow for web based configuration:
Conclusion
WiFi extender N300 setup is very easy by following any of the above setup methods. The breakdown of the process specified above is very simple and easy to understand. By following any of the processes a new user can easily configure the extended device. In case you encounter any issue while performing the setup then you can connect our technical team for help. We will happily assist you.