logo
How To Fix Wavlink Extender Not Connecting To Router Issue?

How To Fix Wavlink Extender Not Connecting To Router Issue?

The Wavlink extender will not connect to router is a very frustrating issue and many users encounter this problem. This can be due to various reasons like incorrect configuration, pending firmware updates, signal interference and many other reasons of similar nature. So if you want to get rid of this problem and thus you want to enjoy wider coverage without any interruptions then check out this whole blog post. We bet by the end of it you’ll be able to successfully link your repeater to the router. 

Initial Checks For Connectivity 

Before you dive into the complex solutions first do some basic checks. So first ensure your router, modem and the Wavlink extender are connected to the well working power outlets that offer uncut supply of electricity. Next up, check the physical proximity between the router and the Wavlink repeater. The Wavlink extender will not connect to router if the distance between the router and the extender is too much. Because for effective signal boosting the extender requires decent signals from the router. So make sure the place where you keep the extender is close to the router and also to the area with wifi dead zone. 

Router Compatibility And Firmware Upgrades

If your router is not compatible with the Wavlink extender then definitely the Wavlink extender will not connect to router. So check the compatibility. For this check the wifi standards. It should be identical with the one that the signal repeater is using. Although almost all Wavlink Extenders offer backward compatibility but still to be on the safer side you should give it a quick check. 

Moving further, generally users do not pay attention to the pending firmware updates. And then these updates become the reason behind connectivity problems. So login into the management page of your router as well as the extender. Look for the pending updates. If found, install them immediately. This will not only solve the connectivity problems but will also amp up your overall experience by giving you access to new features if any and enhancing the security of your network. 

Right Configuration Is Non-Negotiable 

Your Wavlink extender will not connect to router until you conduct the setup which is error free. So here is the step-by-step guidance for the same:

  • First plot the extender nearby router. 
  • Next power it on. 
  • Give it some time to boot up properly. 
  • Now fetch your smart device like a laptop. Enable its wifi. Connect to the SSID which is written on the extender’s base/back panel. 
  • Thereafter, open the internet browser. In the browser’s address column, fill: http://192.168.10.1. Click Enter.
  • Moving further, fill the accurate passkey. It is “admin” by default. Then select the language. Hit on Login. 
  • Finally, select the mode. Input current network’s information. Tap on Connect. 

With these steps your extender will successfully connect to the router. 

Reset And Reconfigure

If you input the wrong password during configuration then definitely your Wavlink extender will not connect to router. So if you no longer remember the passkey of your existing network then you have to reset the router. After resetting, you have to reconfigure it and then use the new password for collaborating the extender to the router. 

Now if everything is to the mark but still the extender isn’t connecting to the router then you need to reset the extender as well. For this you require a sharp component like a paper clip or sturdy toothpick. Now after you activate the router, put the chosen object into the reset port. Push it down. Hold on till the indicators go off. On release the device re-starts and will now operate on its default settings.